Pinouts >  RS-232 and other serial ports and interfaces  >  obsolete computers pinouts
25 pin D-SUB male connector layout
25 pin D-SUB male connector
at the Amiga 1000
Pin Name Dir Description
1SHIELD---Shield Ground
2TXD-->Transmit Data
3RXD<--Receive Data
4RTS-->Request to Send
5CTS<--Clear to Send
6DSR<--Data Set Ready
7GND---System Ground
8CD<--Carrier Detect
9n/c- 
10n/c- 
11n/c- 
12n/c- 
13n/c- 
14-5V-->-5 Volts DC (50mA max)
15AUDO-->Amiga Audio Out (Left)
16AUDI<--Amiga Audio In (Right)
17EB-EB=Buffered Port Clock 716 kHz
18/INT2?Interrupt 2
19n/c- 
20DTR-->Data Terminal Ready
21+5V-->+5 Volts DC
22n/c- 
23+12V-->+12 Volts DC (20 mA max)
24/C2-->C2=Clock 3.58MHz
25/RESET-->Reset
Note: Direction is DTE (Computer) relative DCE (Modem).
Note: Do not connect SHIELD(1) to GND(7)
Pinout status: +0 -0
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
NO DIY devices
Source(s) of this and additional information: Amiga 4000 User"s Guide from Commodore, from Hardware Book
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings