Pinouts >  RS-232 and other serial ports and interfaces  >  DEC pinouts
10 pin IDC male connector layout
10 pin IDC male connector
at the Serial card (is numbering correct??)
Available on the DEC DLV11-J Serial card
Pin Name Dir Description
1 CLK ? Clock
2 GND --- Ground
3 TXD+ --> Transmit data +
4 TXD- --> Transmit data - (0V for RS-232, Reader enable for 20mA)
5 GND --- Ground
6 n/c - Not connected (no pin)
7 RXD- <-- Receive data -
8 RXD+ <-- Receive data +
9 GND --- Ground
10 +12V --> +12 VDC
Note: Direction is Serial card relative other Devices.
Pinout status: +0 -0
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
NO DIY devices
Source(s) of this and additional information: DEC DLV11-J Printset, M8043-0-1, sheet 7 and Ben Harris
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings