Pinouts >  Network hardware interfaces
8 pin RJ45 (8P8C) female connector layout
8 pin RJ45 (8P8C) female connector
at the network interface cards/hubs
It requires four twisted copper pairs and works with category 3 ethernet cable. Rarely used.

100BASE-T4 is an early implementation of Fast Ethernet. 

Pin Name Description
1 TX_D1+ Transmit Data+
2 TX_D1- Transmit Data-
3 RX_D2+ Receive Data+
4 BI_D3+ Bi-directional Data+
5 BI_D3- Bi-directional Data-
6 RX_D2- Receive Data-
7 BI_D4+ Bi-directional Data+
8 BI_D4- Bi-directional Data-

One pair is reserved for transmit, one for receive, and the remaining two will switch direction as negotiated.

Note: TX & RX are swapped on Hub´s. Don´t know about Bi-directional data

How to build Ethernet UTP network cable

8 pin RJ45 (8P8C) male connector layout
8 pin RJ45 (8P8C) male connector
at the cables
Pinout status: +4 -0
According to 4 reports in our database (4 positive and 0 negative) the Ethernet 100Base-T4 pinout should be correct.

Is this pinout
NO DIY devices
Source(s) of this and additional information: Hardware Book, Kim Scholte
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings