Pin | Name | Dir | Description | |
---|---|---|---|---|
1 | SCSI-Mode | SCSI disk mode enable signal | Reserved for SCSI disk mode. | |
2 | Data0 | ![]() |
Data bit 0 | Bit 0 of SCSI data bus |
3 | GND | ![]() |
Signal ground | Ground |
4 | Data1 | ![]() |
Data bit 1 | Bit 1 of SCSI data bus |
5 | Termpwr +5 volts | ![]() |
termination power | Termination power |
6 | Data2 | ![]() |
Data bit 2 | Bit 2 of SCSI data bus |
7 | Data3 | ![]() |
Data bit 3 | Bit 3 of SCSI data bus |
8 | GND | ![]() |
Signal ground | Ground |
9 | ACK | ![]() |
Acknowledge | Handshake signal. When low acknowledges a request for data transfer |
10 | GND | ![]() |
Signal ground | Ground |
11 | Data4 | ![]() |
Data bit 4 | Bit 4 of SCSI data bus |
12 | GND | ![]() |
Signal ground | Ground |
13 | GND | ![]() |
Signal ground | Ground |
14 | Data5 | ![]() |
Data bit 5 | Bit 5 of SCSI data bus |
15 | GND | ![]() |
Signal ground | Ground |
16 | Data6 | ![]() |
Data bit 6 | Bit 6 of SCSI data bus |
17 | GND | ![]() |
Signal ground | Ground |
18 | Data7 | ![]() |
Data bit 7 | Bit 7 of SCSI data bus |
19 | PARITY | ![]() |
Data parity | SCSI data bus parity bit |
20 | GND | ![]() |
Signal ground | Ground |
21 | REQ | ![]() |
Request | Request for a data transfer |
22 | GND | ![]() |
Signal ground | Ground |
23 | BUSY | ![]() |
Busy | When active (low) indicates that the SCSI data bus is busy |
24 | GND | ![]() |
Signal ground | Ground |
25 | ATN | ![]() |
Attention | When active (low) indicates an attention condition |
26 | C/D | ![]() |
Control/data | When active (low) indicates that data is on the SCSI bus. When high, indicates that control signals are on the bus |
27 | RST | ![]() |
Reset | SCSI bus reset |
28 | MSG | ![]() |
Message | Indicates the message phase |
29 | SEL | ![]() |
Select | SCSI select |
30 | I/O | ![]() |
Input/output | Controls the direction of data output. When high, data is input |
Note: Direction is Device relative Bus (other Devices)