Pinouts >  Распиновки разъемов винчестеров других устройств хранения информации  >  obsolete computers pinouts
37 pin D-SUB female connector layout
Разъем 37 pin D-SUB female
at the controller
Can be used to connect a normal IDE harddisk to the Paravision SX1. Paravision was earlier known as Microbotics
Description D-Sub IDC
Drive Reset11
Data bit 0217
Data bit 2313
Data bit 449
Data bit 655
Ground62
Data bit 874
Data bit 1088
Data bit 12912
Data bit 141016
Ground11+1219
Ground13+1422
Ground15+1624
Ground1726
5V Power18n/c
5V Power19n/c
Ground2030
Data bit 12121
Data bit 32222
Data bit 52323
Data bit 72424
Ground2540
Data bit 92626
Data bit 112727
Data bit 132828
Data bit 152929
I/O Write3023
I/O Read3125
Interrupt Request3231
Address bit 23336
Address bit 13433
Address bit 03535
Chip Select 13638
Chip Select 03737
Note: Pin 18+19 (+5V) can be used to power the harddisk. But most harddisks require both +5V and +12V.
40 pin IDC female connector layout
Разъем 40 pin IDC female
at the hard disk
Статус распиновки: +0 -2
На распиновку Paravision SX1 to IDE cable есть 2 отзыв(а): 0 положительных и 2 отрицательных.

Эта распиновка
Нет DIY устройств
Источник(и) этой и дополнительной информации: Hardware Book
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings