Pinouts >  Распиновки разъемов винчестеров других устройств хранения информации
40 pin IDC female connector layout
Разъем 40 pin IDC female
at the Controller

The IDE interface requires only one cable. All pins straight from 1 to 1, 2 to 2 and so on. The drives can be connected in any order. Only remember that one should be jumpered as Master and the other as Slave. If only one drive is used, jumper it as Single (if such a mode exists, or most common Master else). 

Controller         Drive 1 or 2   Drive 1 or 2
+--+                   +--+            +--+
|::|===================|::|============|::|  <-Pin 1
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
|::|===================|::|============|::|
+--+                   +--+            +--+
  Controller Drive 1 Drive 2
Wire 1-40 1-40 1-40 1-40
40 pin IDC female connector layout
Разъем 40 pin IDC female
at the Drive 1 & Drive 2
Статус распиновки: +7 -0
На распиновку IDE cable есть 7 отзыв(а): 7 положительных и 0 отрицательных.

Эта распиновка
Нет DIY устройств
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings