Obsolete hardware connectors pinouts

C64 Centronics Printer cable pinout

cable wiring

bookmark this page
24 pin DZM 12 DREH connector layout
24 pin DZM 12 DREH connector
at the C64 UserPort

Requires a cartridge with Centronics support (TFCIII or ActionReplay.)

  C64 Dir Printer  
GND 1,12,A,N --- 19-30,33 Ground
FLAG2 B <-- 10 Acknowledge
PB0 C --> 2 Data 0
PB1 D --> 3 Data 1
PB2 E --> 4 Data 2
PB3 F --> 5 Data 3
PB4 H --> 6 Data 4
PB5 J --> 7 Data 5
PB6 K --> 8 Data 6
PB7 L --> 9 Data 7
PA2 M --> 1 Strobe
/Reset 3 --> 31 Initialize Printer
 

Is there anything to be corrected? Edit this page!
36 pin CENTRONICS male connector layout
36 pin CENTRONICS male connector
at the Printer
Source(s) of this and additional information: CBM Memorial Page Pinouts, pinout by Roy Kannady, from Hardware Book, http://www.hardwarebook.info/C64/128_User_Port
Contributor(s): , Friderik Back
This information should be correct, but we are not sure.
Is this document CORRECT or INCORRECT?.
Pinouts.ru >  Parallel interfaces and ports cables schemes >  Pinout of C64 Centronics Printer cable and layout of connector and 36 pin CENTRONICS male connector. Is this document correct or incorrect?
Is it correct?:
should be correct
1 comments
Last updated 2011-08-10 16:18:17. Edit this page.
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2010 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
[an error occurred while processing this directive]