Obsolete hardware connectors pinouts

Parallel (Olivetti M10) pinout

parallel interface

bookmark this page
26 pin IDC male connector layout
26 pin IDC male connector
at the computer

Available on an old portable computer called Olivetti M10

Pin Name Dir Description
1/STROBE-->Strobe
2D0-->Data Bit 0
3D1-->Data Bit 1
4D2-->Data Bit 2
5D3-->Data Bit 3
6D4-->Data Bit 4
7D5-->Data Bit 5
8D6-->Data Bit 6
9D7-->Data Bit 7
10/ACK<--Acknowledge
11BUSY<--Busy
12PE<--Paper End
13SELIN<--Select In
14GND---Signal Ground
15GND---Signal Ground
16GND---Signal Ground
17GND---Signal Ground
18GND---Signal Ground
19GND---Signal Ground
20GND---Signal Ground
21GND---Signal Ground
22GND---Signal Ground
23GND---Signal Ground
24GND---Signal Ground
25RESETGND---Reset Ground
26/RESET<--Reset
Note: Direction is Computer relative Device.

Is there anything to be corrected? Edit this page!
Source(s) of this and additional information: Hardware Book, Filippo Fiani
This information should be correct, but we are not sure.
Is this document CORRECT or INCORRECT?.
Pinouts.ru >  Parallel interfaces pinouts >  Pinout of Parallel (Olivetti M10) and layout of 26 pin IDC male connector. Is this document correct or incorrect?
Is it correct?:
unknown
no visitors comments
Last updated 2011-08-10 16:19:34. Edit this page.
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2010 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
[an error occurred while processing this directive]