Распиновки кабелей и переходников для клавиатур, мышей и т.д.
This adapter will enable you to use a mouse with a 6 pin Mini-DIN (PS/2) connector to a computer with a 9 pin D-SUB (Serial) connector. This requires that the mouse handles both protocols. A mouse like this is sometimes referred to as a combo-mouse.

The Serial Mouse uses a RS-232 style interface with -5 to -12 VDC as logical 1 and +5 to +12 VDC as logical 0. The PS/2 mouse interface is a TTL-style interface, which uses 0 - +2 VDC as logical 0 and +3 - +5 VDC as logical 1.

In addition - and to make things worse - the RS-232 is an asynchronous interface, the PS/2 interface is a synchronous, where the data is sent along with a clock signal. It uses a simplified 4-wires serial interface with +5VDC (for the transceiver), GND, keyboard / mouse clock and keyboard / mouse data. The data and clock line can be used from the keyboard / mouse controller and the attached device as well following a particular handshake, which defines which is the active sender and which is the receiver. So: it is not *that* easy converting serial mouse to PS/2 and vice versa.

RS232 adapter that should work for Microsoft IntelliMouse:

PS/2 Pin RS-232 pin Description
1 1  
2 n/c  
3 3  
4 5  
5 7  
6 n/c  



The dual mode mice have an automatic logic detection and form of adaptive electronic interface, which detects whether the mouse is attached to a serial port or a PS/2 port and sets the output drivers accordingly.

  Mini-DIN D-SUB  
RxD 2 2 RxD
TxD 6 3 TxD
+5V 4 7 RTS


9 pin D-SUB female схематический вид разъема
Разъем 9 pin D-SUB female
at the computer
На эту распиновку есть 12 отзыв(а): 4 положительных и 7 отрицательных.

Эта распиновка
Источник(и) этой и дополнительной информации: Hardware Book, Tomas Ogren, Thomas Eschenbacher
This page contain parts under Copyright © 2000-2018 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Old.Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.