HDD and other storage devices connectors pinouts
SCSI=Small Computer System Interface. Based on an original design by Shugart Associates. SCSI was ratified in 1986.

 

SCSI Single-ended

Pin Name Dir Description
2 DB0 <-> Data Bus 0
4 DB1 <-> Data Bus 1
6 DB2 <-> Data Bus 2
8 DB3 <-> Data Bus 3
10 DB4 <-> Data Bus 4
12 DB5 <-> Data Bus 5
14 DB6 <-> Data Bus 6
16 DB7 <-> Data Bus 7
18 PARITY <-> Data Parity (odd Parity)
20 GND --- Ground
22 GND --- Ground
24 GND --- Ground
26 TMPWR <-> Termination Power
28 GND --- Ground
30 GND --- Ground
32 /ATN <-- Attention
34 GND --- Ground
36 /BSY <-> Busy
38 /ACK <-- Acknowledge
40 /RST <-> Reset
42 /MSG --> Message
44 /SEL <-> Select
46 /C/D --> Control/Data
48 /REQ --> Request
50 /I/O --> Input/Output

Note: Direction is Device relative Bus (other Devices).
All odd-numbered pins, except pin 25, are connected to ground. Pin 25 is left open.

 

SCSI Differential

 

Pin Name Dir Description
01 GND --- Ground
02 GND --- Ground
03 +DB0 <-> +Data Bus 0
04 -DB0 <-> -Data Bus 0
05 +DB1 <-> +Data Bus 1
06 -DB1 <-> -Data Bus 1
07 +DB2 <-> +Data Bus 2
08 -DB2 <-> -Data Bus 2
09 +DB3 <-> +Data Bus 3
10 -DB3 <-> -Data Bus 3
11 +DB4 <-> +Data Bus 4
12 -DB4 <-> -Data Bus 4
13 +DB5 <-> +Data Bus 5
14 -DB5 <-> -Data Bus 5
15 +DB6 <-> +Data Bus 6
16 -DB6 <-> -Data Bus 6
17 +DB7 <-> +Data Bus 7
18 -DB7 <-> -Data Bus 7
19 +DBP <-> +Data Bus Parity (odd Parity)
20 -DBP <-> -Data Bus Parity (odd Parity)
21 DIFFSENS ? ???
22 GND --- Ground
23 res - Reserved
24 res - Reserved
25 TERMPWR <-> Termination Power
26 TERMPWR <-> Termination Power
27 res - Reserved
28 res - Reserved
29 +ATN <-- +Attention
30 -ATN <-- -Attention
31 GND --- Ground
32 GND --- Ground
33 +BSY <-> +Bus is busy
34 -BSY <-> -Bus is busy
35 +ACK <-- +Acknowledge
36 -ACK <-- -Acknowledge
37 +RST <-> +Reset
38 -RST <-> -Reset
39 +MSG --> +Message
40 -MSG --> -Message
41 +SEL <-> +Select
42 -SEL <-> -Select
43 +C/D --> +Control or Data
44 -C/D --> -Control or Data
45 +REQ --> +Request
46 -REQ --> -Request
47 +I/O --> +In/Out
48 -I/O --> -In/Out
49 GND --- Ground
50 GND --- Ground

Note: Direction is Device relative Bus (other Devices)

-Control or Data

50 pin IDC male connector layout
50 pin IDC male connector
at the controller & harddisk
50 pin IDC female connector layout
50 pin IDC female connector
at the cable
According to 3 reports in our database (3 positive and 0 negative) this pinout should be correct.

Is this pinout
This page contain parts under Copyright © 2000-2015 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to Old.Pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.