Obsolete hardware connectors pinouts

SCSI Centronics 50 pin (Single-ended) pinout

hard drive connector

bookmark this page
50 pin Amphenol female connector layout
50 pin Amphenol female connector
at the controller & devices

use RJ-21 (or RJ21) registered jack standard connector, also known as a 50-pin telco connector, or an Amphenol connector.

Pin Name Dir Description
1-25 GND --- Ground
26 DB0 <-> Data Bus 0
27 DB1 <-> Data Bus 1
28 DB2 <-> Data Bus 2
29 DB3 <-> Data Bus 3
30 DB4 <-> Data Bus 4
31 DB5 <-> Data Bus 5
32 DB6 <-> Data Bus 6
33 DB7 <-> Data Bus 7
34 PARITY <-> Data Parity (odd Parity)
35 GND --- Ground
36 GND --- Ground
37 GND --- Ground
38 TMPWR <-> Termination Power
39 GND --- Ground
40 GND --- Ground
41 /ATN <-- Attention
42 n/c - Not connected
43 /BSY <-> Busy
44 /ACK <-- Acknowledge
45 /RST <-> Reset
46 /MSG --> Message
47 /SEL <-> Select
48 /C/D --> Control/Data
49 /REQ --> Request
50 /I/O --> Input/Output
Note: Direction is Device relative Bus (other Devices)
 
According to SCSI-II X3T9.2/86-109 rev 10h 11Nov91, 12,14,37&39 are RESERVED, 13 is OPEN and 42 is GROUND. 

Is there anything to be corrected? Edit this page!
50 pin Amphenol male connector layout
50 pin Amphenol male connector
at the cable
Source(s) of this and additional information: Hardware Book
This information should be correct, but we are not sure.
Is this document CORRECT or INCORRECT?.
Pinouts.ru >  HDD connectors pinouts >  Pinout of SCSI Centronics 50 pin (Single-ended) and layout of 50 pin Amphenol female connector and 50 pin Amphenol male connector. Is this document correct or incorrect?
Is it correct?:
may be incorrect
2 comments
Last updated 2011-10-08 22:26:23. Edit this page.
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2010 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
[an error occurred while processing this directive]