Obsolete hardware connectors pinouts

Paravision SX1 to IDE cable pinout

hard disks cables wiring

bookmark this page

Can be used to connect a normal IDE harddisk to the Paravision SX1. Paravision was earlier known as Microbotics

Description D-Sub IDC
Drive Reset11
Data bit 0217
Data bit 2313
Data bit 449
Data bit 655
Ground62
Data bit 874
Data bit 1088
Data bit 12912
Data bit 141016
Ground11+1219
Ground13+1422
Ground15+1624
Ground1726
5V Power18n/c
5V Power19n/c
Ground2030
Data bit 12121
Data bit 32222
Data bit 52323
Data bit 72424
Ground2540
Data bit 92626
Data bit 112727
Data bit 132828
Data bit 152929
I/O Write3023
I/O Read3125
Interrupt Request3231
Address bit 23336
Address bit 13433
Address bit 03535
Chip Select 13638
Chip Select 03737

Is there anything to be corrected? Edit this page!
Source(s) of this and additional information: Hardware Book
This information should be correct, but we are not sure.
Is this document CORRECT or INCORRECT?.
Pinouts.ru >  Disk drives cables >  Pinout of Paravision SX1 to IDE cable and layout of 37 pin D-SUB female connector and 40 pin IDC female connector. Is this document correct or incorrect?
Is it correct?:
may be incorrect
2 comments
Last updated 2011-08-10 16:19:34. Edit this page.
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2010 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to pinouts.ru . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
[an error occurred while processing this directive]