QTEK 2020,8080 ,O2 XDAII, I-Mate - PowerUp specification users reports and reviews |
Date | Content Revision |
User opinion | Comment | Approved by moderator? |
---|---|---|---|---|
INCORRECT | APPROVED | |||
INCORRECT | Ne rasbotaet sxema | APPROVED | ||
CORRECT | Information is right. To make the PDA to work, it must happen: - put red switch battery lock to ON (as if it were locking a battery) - pin 2 3 (+5V) must be connected by battery | APPROVED | ||
2009-02-25 11:42:49 | rev. 2 | CORRECT | This is correct. Those are 6 pins on battery conector, and if you connect 5v and gnd as shown you will be abile to power on your device... but before you do that you must locate battery or battery cower swich... it's switch that tell's your device battery or battery cower is in its place.... | APPROVED |
2010-05-28 20:21:32 | rev. 2 | CORRECT | yes this information is correct.. but warning dont try to charge lipol batery with normal batery charger example from other mobile lipol bytery needs special charger wehen u tray to charge with normal charger byterry may explode!!! trust me im a electrician and i know how it works :) | APPROVED |
2014-02-23 16:23:12 | rev. 3 | CORRECT | APPROVED |
Date | Content Revision |
Author | Comment |
---|---|---|---|
2010-06-10 22:49:53 | rev. 2 | lamka | thynk uyou for this page :) |
Pinouts.ru > Pinout of QTEK 2020,8080 ,O2 XDAII, I-Mate - PowerUp and layout of connector |
should be correct |