CD changer old 13 pole connector specification users reports and reviews |
Date | Content Revision |
User opinion | Comment | Approved by moderator? |
---|---|---|---|---|
2009-09-19 14:34:50 | rev. 2 | ERROR FIXED | The diagram is wrong. It should be 3 rows of 4 pins and the last one below. See http://wa8lmf.net/miscinfo/KenDIN13-Male.pdf | APPROVED |
2010-02-21 19:26:43 | rev. 2 | ERROR FIXED | The Pins numbering is not correct this numbering is at the "Head Unit" side not the CD changer side | APPROVED |
2010-02-23 12:35:33 | rev. 3 | ERROR FIXED | ihave a kenwood cd changer. but the pins are 4 wide in three rows and one below in the middle. Mark | APPROVED |
2010-07-20 20:38:49 | rev. 3 | ERROR FIXED | As the others have said, the diagram should have 4 columns and 3 rows, with the single pin 13 on the fourth row. The numbering on the table is correct, though. | APPROVED |
2012-04-25 01:16:28 | rev. 3 | CORRECT | Very helpful info. Thank you! | APPROVED |
2017-12-19 10:10:49 | rev. 4 | CORRECT | APPROVED | |
2018-10-14 14:42:42 | rev. 5 | CORRECT | Works on kdc c465 6 disk kenwood changer | APPROVED |
Date | Content Revision |
Author | Comment |
---|---|---|---|
2018-06-20 18:12:39 | rev. 4 | lenhon | CH-DATAC AND CH-DATAH is as tx and rx ? |
Pinouts.ru > Pinout of Kenwood CD changer |
should be correct |