Pinouts >  Схемы кабелей для последовательных портов  >  Conrad pinouts

5 pins connector at the multimeter
This connector is available on the Conrad Electronics Multimeter 3610D and is used to connect it to a computer.
Conrad Name Description Dir
1 RTS Request To Send <--
2 RXD Receive Data -->
3 TXD Transmit Data <--
4 DTR Data Terminal Ready <--
5 GND Ground ---

Note: Since the multimeter is a DCE the pin naming can seem strange.

Статус распиновки: +0 -0
На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
Нет DIY устройств
Источник(и) этой и дополнительной информации: Hardware Book, Anselm Belz
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings