Pinouts >  Распиновки последовательных портов  >  Apple pinouts
9 pin D-SUB female connector layout
Разъем 9 pin D-SUB female
This connector is present on Macintosh 128K, 512K, and 512K enhanced.
Pin Name Dir Description
1 GND --- Ground
2 +5V --> +5 VDC. Dont use this one, it may be converted into output handshake in later equipment.
3 GND --- Ground
4 Tx+ --> Transmit Data, positive going component
5 Tx- --> Transmit Data, negative going component
6 +12V --> +12 VDC
7 DSR/HSK <-- Handshake input. Signal name depends on mode: Used for Flow Control or Clock In.
8 Rx+ <-- Receive Data, positive going component
9 Rx- <-- Receive Data, negative going component

a. When connecting to an RS-232 device, use HSKi with data set ready (DSR) or other handshaking signals, depending on the device to be connected.
 

9 pin D-SUB male connector layout
Разъем 9 pin D-SUB male
На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
Источник(и) этой и дополнительной информации: Apple Tech Info Library, Article ID: TECHINFO-0001424; Ben Harris
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings