Pinouts >  MP3 плееры и гаджеты  >  PalmOne pinouts
10 pin PALM proprietary connector layout
Разъем 10 pin PALM proprietary
The Palm Serial Connector used before 2000/2001.
Для этой распиновки есть 6 совместимых устройств. Показать>

Pin Signal Description
1 DTR non-standart implementation of DTR. As long as the transceiver is enabled this pin outputs an asserted signal. 3.0 volts when transceiver shutdown (normal mode), 6.0 volts when transceiver enabled (Hotsync)
2 Vbat, +3.3v normally connected to HotSync (pin 7) with button
3 RxD GPS T
4 RTS  
5 TxD GPS R
6 CTS  
7 HotSync IRQ link to 3.3v (pin 2) for HotSync. Interrupt line for waking up device (initiate HotSync process in PalmOS).
8 ID Palm modem connect this pin to 3.3v (pin 2) by 20Kohm link
9 N/C* DC In in Palm III (+5VDC)
10 GND GPS -

*Palm V does not contain an internal charging circuit.

Maximum transmission rate is 115200 bps (57600 bps for modem).


 


 

Here is Palm Serial cable scheme


 


 


 

9 pin D-SUB female connector layout
Разъем 9 pin D-SUB female
Статус распиновки: +5 -1
На распиновку Palm Pilot, Palm III, V, VII, VIIx, Handera cable connector есть 7 отзыв(а): 5 положительных и 1 отрицательных.

Эта распиновка
Нет DIY устройств
Источник(и) этой и дополнительной информации: kolumbus.fi
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings