Pinouts >  Кабели для локальных сетей
8 pin RJ45 (8P8C) male connector layout
Разъем 8 pin RJ45 (8P8C) male
at the network interface card 1
This cable can be used to cascade hubs, or for connecting two Ethernet stations back-to-back without a hub. It works with both 10Base-T and 100Base-TX

This is an old version of Ethernet RJ45 connection wiring. 

Name NIC1 NIC2 Name
TX+ 1 3 RX+
TX- 2 6 RX-
RX+ 3 1 TX+
RX- 6 2 TX-

Note 1: It´s important that each pair is kept as a pair. TX+ & TX- must be in the pair, and RX+ & RX- must together in another pair. (Just as the table above shows). Note 2: You could also connect 4-4, 5-5, 7-7, 8-8. 

How to wire an Ethernet  network RJ45 connection cable

8 pin RJ45 (8P8C) male connector layout
Разъем 8 pin RJ45 (8P8C) male
at the network interface card 2
Статус распиновки: +6 -2
На распиновку Ethernet 10Base-T crossover cable есть 8 отзыв(а): 6 положительных и 2 отрицательных.

Эта распиновка
Нет DIY устройств
Источник(и) этой и дополнительной информации: Hardware Book, Jason D. Pero , Oscar Fernandez Sierra, Jeffrey R. Broido, Patrick Smart
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings