Pinouts >  Motherboard connectors  >  obsolete computers pinouts

44 pins connector
Available at the Commodore 128
Pin Name Description
1 GND System Ground
2 +5V System Vcc
3 +5V System Vcc
4 /IRQ Interrupt request
5 R/W System Read/Write Signal
6 DClock 8.18MHz Video Dot Clock
7 I/O1 I/O Chip select $de00-deff
8 /GAME Sensed for memory map configuration
9 /EXROM Sensed for memory map configuration
10 I/O2 I/O Chip select $df00-dfff
11 /ROML External ROM select $8000-Bfff
12 BA Bus available output
13 /DMA Direct memory access input
14 D7 Data bit 7
15 D6 Data bit 6
16 D5 Data bit 5
17 D4 Data bit 4
18 D3 Data bit 3
19 D2 Data bit 2
20 D1 Data bit 1
21 D0 Data bit 0
22 GND System Ground
     
A GND System Ground
B /ROMH External ROM Select $c000-ffff
C /RESET System Reset Signal
D /NMI Non-Maskable Interrupt
E 1MHz System 1MHz clock
F TA15 Translated address bit 15
H TA14 Translated address bit 14
J TA13 Translated address bit 13
K TA12 Translated address bit 12
L TA11 Translated address bit 11
M TA10 Translated address bit 10
N TA9 Translated address bit 9
P TA8 Translated address bit 8
R SA7 Shared address bit 7
S SA6 Shared address bit 6
T SA5 Shared address bit 5
U SA4 Shared address bit 4
V SA3 Shared address bit 3
W SA2 Shared address bit 2
X SA1 Shared address bit 1
Y SA0 Shared address bit 0
Z GND System Ground
Pinout status: +0 -0
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
NO DIY devices
Source(s) of this and additional information: Commodore 128 Programmers reference guide.
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings