for J200i, J210i, J300i, K300i, K700, K700i, S700, S700i, F500, F500i, K500, K500i, T616, T628, T637, P800, P802, P900, P908, P910, T200, T202, T226, T226s, T230, T238, T290, T292, T300, T302, T306, T310, T312, T316, T20, T28, T29, T36, T39m, T39mc, R520, R520m, R520mc, T65s, T60c, T62u, T68i, T68m, T68mc, T68ie, z1010, T100, T102, T105, T106, T66, T600, R600, R600s, R600sc, A2618, A2628, A3618, Z200, Z300, Z500i, Z600, Z608, Z1010, S700, V600i, V800
| bottom Pin |
Name | Direction | Description |
|---|---|---|---|
| 1 | ATMS |  |
Audio to mobile |
| 2 | AFMS/RTS |  |
Audio from mobile/RTS (connected to GND in cable?) |
| 3 | CTS/ONREQ |  |
CTS/Mobile Station On REQuest (connected to GND in cable?) |
| 4 | data in | |
Data to mobile (Rx). (Tx for K300i) |
| 5 | data out | |
Data from mobile (Tx). (Rx for K300i) |
| 6 | ACC in | |
Accessory control to mobile. Used as Rx in some models (i.e. T68) for flashing. |
| 7 | ACC out | |
Accessory control from mobile/handsfree sense. Used as Tx in some models (i.e. T68) for flashing. |
| 8 | AGND | |
Audio signal ground + 0V reference |
| 9 | flash | |
Flash memory voltage + Service (shorted to pin 11 in service cable) |
| 10 | DGND | |
Digital ground |
| 11 | Vcc | |
DC + for battery charging + External accessory powering |
Pinout by Cruiser team:
| Pin | Signal | Description |
| 1 | ATMS | |
| 2 | AFMS | |
| 3 | CTS_ON | |
| 4 | DTMS | |
| 5 | DFMS | |
| 6 | CTMS | |
| 7 | CFMS | |
| 8 | AGND | |
| 9 | VPPFLASH | |
| 10 | DGND | |
| 11 | DCIO |
CTMS stands for Control To Mobile Station; CFMS stands for Control From Mobile Station; DTMS stands for Data To Mobile Station; DFMS stands for Data From Mobile Station
Standard cable is Sony Ericsson DCU-11
The (Tx)&(Rx) are reverse for K300i model, you must connect CTS & DGND together on board and connect the common wire to CTS(Pin3) in phone connector. If your cable is working fine then dont change it.
correct
incorrect