Pinouts >  OEM Peugeot, Citroen, Opel Head units  >  Fiat pinouts
36 (20+8+8) pin Head Unit / Car Stereo ISO connector layout
36 (20+8+8) pin Head Unit / Car Stereo ISO connector
at the head unit
Grundig AD182H and AD185H (x)
A: Power B: Speakers C: Changer / special
1. weight (x) 1. RR 1. -
2. tel mute (x) 2. RR - 2. -
3. ant control (x) 3. RF 3. -
4. +12 V ACC 4. RF - 4. -
5. - 5. LF 5. -
6. Illumination 6. LF - 6. -
7. +12 V BATT 7. LR 7. -
8. Ground (-) 8. LR - 8. pilot - mass
Radio has a logic of ignition, so the pros are swapped places.  
  • R - right (right)
  • L - Left (left), second letter indicates the location of
     
  • R - Rear (rear)
  • F - Front (front) 
    - means the negative speaker terminal 
    Note: Do not connect (-) with the mass of the vehicle and may damage the amplifier.
 9. pilot - in
10. -
11. -
12 -
13. CD-Bus
14. -
15. CD-Bus GND
16. 12 V constant
17. +12 V from the radio-controlled
18. CD-NF GND
19. NF CD-Left
20. Right-NF CD
CD Changer Interface 13-20

This is a standard Grundig MCD36/40. Some versions have a car with the steering wheel radio controls, and if it is connected to the remote connector (not always on the radio is a connector). This is a typical resistor ladder. The contacts marked (x) occur only in the model AD185H. 

Pinout status: +0 -0
There are no any reports for this pinout! You may rate this document by clicking the button below.

Is this pinout
NO DIY devices
1 Information source(s)
Copyright © 2000-2024 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
Change privacy settings