Pinouts >  Распиновки параллельных портов  >  Sun pinouts
26 pin D-SUB connector layout
Разъем 26 pin D-SUB
at the computer
Available on SUN SPARCengine motherboards
Pin Name Dir Description
1 /STROBE --> Strobe
2 D0 --> Data Bit 0
3 D1 --> Data Bit 1
4 D2 --> Data Bit 2
5 D3 --> Data Bit 3
6 D4 --> Data Bit 4
7 D5 --> Data Bit 5
8 D6 --> Data Bit 6
9 D7 --> Data Bit 7
10 /ACK <-- Acknowledge
11 BUSY <-- Busy
12 PE <-- Paper End
13 SEL <-- Select
14 /AUTOFD --> Autofeed
15 /ERROR <-- Error
16 /RESET --> Reset
17 /SELIN --> Select In
18 GND --- Signal Ground
19 GND --- Signal Ground
20 GND --- Signal Ground
21 GND --- Signal Ground
22 GND --- Signal Ground
23 GND --- Signal Ground
24 GND --- Signal Ground
25 GND --- Signal Ground
26 GND --- Signal Ground

Note: Direction is Computer relative Device.

Статус распиновки: +0 -0
На эту распиновку нет ни одного отзыва! Если вы знаете, правильная она или нет, - нажмите на соответствующую кнопку ниже.

Эта распиновка
Нет DIY устройств
Источник(и) этой и дополнительной информации: SUN SPARCengine 5 manual at SUN manuals siteSUN SPARCengine Ultra 20 OEM Manual, from Hardware Book
Copyright © 2000-2023 by pinouts.ru team, except user uploaded images.
No portion of this webpage may be reproduced in any form without visible link to pinouts.ru .
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.